Kingroon KP3S: Difference between revisions
mNo edit summary |
|||
| Line 1: | Line 1: | ||
= Hardware Mods = | = Hardware Mods = | ||
== Change TMC drivers to UART Mode == | == Change TMC drivers to UART Mode == | ||
* Solder TMC driver "UART" pins to (PA3, PA6, PA1)=E1-connector, (PE5)=TC-connector | * Solder TMC driver "UART" pins to (PA3, PA6, PA1)=E1-connector, (PE5)=TC-connector | ||
| Line 8: | Line 6: | ||
* https://www.3d-druck-community.de/showthread.php?tid=28594 | * https://www.3d-druck-community.de/showthread.php?tid=28594 | ||
* https://marlinfw.org/docs/hardware/tmc_drivers.html | * https://marlinfw.org/docs/hardware/tmc_drivers.html | ||
== ABL Sensor == | |||
* LJ12A3-4-Z/BX (4mm, NPN, Normally Open) | |||
== Mini Afterburner == | == Mini Afterburner == | ||
Revision as of 09:33, 3 November 2021
Hardware Mods
Change TMC drivers to UART Mode
- Solder TMC driver "UART" pins to (PA3, PA6, PA1)=E1-connector, (PE5)=TC-connector
- https://github.com/makerbase-mks/MKS-Robin-Nano-V1.X/blob/master/hardware/MKS%20Robin%20Nano%20V1.2_003/MKS%20Robin%20Nano%20V1.2_003%20PIN.pdf
- https://github.com/makerbase-mks/MKS-Robin-Nano-V1.X/issues/78
- https://www.3d-druck-community.de/showthread.php?tid=28594
- https://marlinfw.org/docs/hardware/tmc_drivers.html
ABL Sensor
- LJ12A3-4-Z/BX (4mm, NPN, Normally Open)
Mini Afterburner
Dual Gear Extruder
Software Mods
Installing Klipper
- ~ git clone https://github.com/th33xitus/kiauh.git
- cd kiauh
- ./kiauh.sh
Enable extra low-level STMicroelectronics STM32 STM32F103 28KiB bootloader 8 MHZ crystal USART PB11/PB10 250000 Baud !PC6,!PD13 GPIO pins at startup
- cd ~/klipper/
- ./scripts/update_mks_robin.py ./out/klipper.bin ./out/Robin_nano.bin
Klipper printer.cfg
- https://3dprintbeginner.com/how-to-install-klipper-on-kingroon-kp3s/
- https://gist.github.com/nezuppo/0d06444bbf61e6d6a8953caf31e5f25d
- Extruder=7.41