Revision as of 17:57, 30 October 2021

Hardware Mods

Enable extra low-level
STMicroelectronics STM32
STM32F103
28KiB bootloader
8 MHZ crystal
USART PB11/PB10
250000 Baud
!PC6,!PD13 GPIO pins at startup

@@ Line 1: / Line 1: @@
+= Hardware Mods =
+== Change TMC drivers to UART Mode ==
+= Software Mods =
+== Installing Klipper ==
+* ~ git clone https://github.com/th33xitus/kiauh.git
+* cd kiauh
+* ./kiauh.sh
+<pre>
+Enable extra low-level
+STMicroelectronics STM32
+STM32F103
+KiB bootloader
+MHZ crystal
+USART PB11/PB10
+Baud
+!PC6,!PD13 GPIO pins at startup
+</pre>
+* cd ~/klipper/
+* ./scripts/update_mks_robin.py ./out/klipper.bin ./out/Robin_nano.bin
+== Klipper printer.cfg ==
+* https://3dprintbeginner.com/how-to-install-klipper-on-kingroon-kp3s/
+* https://gist.github.com/nezuppo/0d06444bbf61e6d6a8953caf31e5f25d
+* Extruder=7.41
 [[Category:Hardware]]