3D Printing: Difference between revisions

From Wiki
 
Line 72: Line 72:
|
|
|
|
|
|100mm/s
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
Line 83: Line 83:
|
|
|
|
|
|180mm/s
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
Line 94: Line 94:
|
|
|
|
|
|30mm/s
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|-
|
|60%
|
|
|40%
|
|
|
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
|<nowiki>-</nowiki>
Line 143: Line 132:
|
|
|
|
|
|40%+
|
|<nowiki>-</nowiki>
|
|<nowiki>-</nowiki>
|}
|}


[[Category:Hardware]]
[[Category:Hardware]]

Latest revision as of 16:30, 25 September 2022

Klipper with Fluidd


Klipper with OctoPrint

git clone https://github.com/Klipper3d/klipper
./klipper/scripts/install-octopi.sh
  • Webinterface > Serial Connection > General > /tmp/printer
  • Webinterface > Serial Connection > Behaviour > Error > Cancel (DO NOT DISCONNECT)
  • Webinterface > Serial Connection > Behaviour > Cancelling > Uncheck Attempt
edit:
~/printer.cfg

Klipper on Kingroon KP3S

Slicer Settings

PLA PETG ABS
KP3S Ender CR10 KP3S Ender CR10 KP3S Ender CR10
Skin Overlap Percentage 5% 5% 15% - -
Infill Overlap Percentage 10% 10% 20% - -
Printing Temperature 215°C 240°C 245°C - -
Build Plate Temperature 60°C 70°C 100°C - -
Print Speed 100mm/s 100mm/s 100mm/s - -
Travel Speed 180mm/s 180mm/s 180mm/s - -
Initial Layer Speed 30mm/s 30mm/s 30mm/s - -
Retraction Distance 0.0 0.8mm 0.8mm - -
Retraction Speed - 20mm/s 20mm/s - -
Retraction Extra Prime - 0.35mm³ 0.5mm³ - -
Fan Speed 60% 40% 40%+ - -