Raspberry Pi/USB-Ethernet DM9601

From Wiki
< Raspberry Pi
Revision as of 11:50, 28 February 2018 by Marcluer (talk | contribs)

problems

  • not working after boot / reboot
  • only working after unplug / plug
  • crashes after transferring data (test with iperf3)

dmesg on plug-in

[   61.502917] Indeed it is in host mode hprt0 = 00021d01
[   61.712828] usb 1-1: new full-speed USB device number 2 using dwc_otg
[   61.715117] Indeed it is in host mode hprt0 = 00021d01
[   61.967306] usb 1-1: New USB device found, idVendor=0fe6, idProduct=9700
[   61.967324] usb 1-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[   61.967332] usb 1-1: Product: USB 2.0 10/100M Ethernet Adaptor
[   62.171082] dm9601 1-1:1.0 eth0: register 'dm9601' at usb-20980000.usb-1, Davicom DM96xx USB 10/100 Ethernet, 00:e0:4c:53:xx:xx
[   62.171801] usbcore: registered new interface driver dm9601
[   62.446328] dm9601 1-1:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
[   62.533322] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   63.568313] dm9601 1-1:1.0 eth0: kevent 4 may have been dropped
[   63.576365] dm9601 1-1:1.0 eth0: kevent 4 may have been dropped
[   63.584338] dm9601 1-1:1.0 eth0: kevent 4 may have been dropped
[   63.594377] dm9601 1-1:1.0 eth0: kevent 4 may have been dropped
[   63.594638] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   63.640037] dm9601 1-1:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF
[   63.750834] dm9601 1-1:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0xFFFF