3D Printing: Difference between revisions
| Line 73: | Line 73: | ||
| | | | ||
| | | | ||
| | |<nowiki>-</nowiki> | ||
| | |<nowiki>-</nowiki> | ||
|- | |- | ||
|Travel Speed | |Travel Speed | ||
| Line 84: | Line 84: | ||
| | | | ||
| | | | ||
| | |<nowiki>-</nowiki> | ||
| | |<nowiki>-</nowiki> | ||
|- | |- | ||
|Initial Layer Speed | |Initial Layer Speed | ||
| Line 95: | Line 95: | ||
| | | | ||
| | | | ||
| | |<nowiki>-</nowiki> | ||
| | |<nowiki>-</nowiki> | ||
|- | |- | ||
|Fan Speed | |Fan Speed | ||
| Line 106: | Line 106: | ||
| | | | ||
| | | | ||
| | |<nowiki>-</nowiki> | ||
| | |<nowiki>-</nowiki> | ||
|- | |- | ||
| Retraction Distance | | Retraction Distance | ||
Revision as of 12:37, 24 September 2022
Klipper with Fluidd
- Download FluiddPi Image: https://github.com/fluidd-core/FluiddPI
- Do updates later from Web GUI
Klipper with OctoPrint
git clone https://github.com/Klipper3d/klipper ./klipper/scripts/install-octopi.sh
- Webinterface > Serial Connection > General > /tmp/printer
- Webinterface > Serial Connection > Behaviour > Error > Cancel (DO NOT DISCONNECT)
- Webinterface > Serial Connection > Behaviour > Cancelling > Uncheck Attempt
edit: ~/printer.cfg
Klipper on Kingroon KP3S
Slicer Settings
| PLA | PETG | ABS | |||||||
|---|---|---|---|---|---|---|---|---|---|
| KP3S | Ender | CR10 | KP3S | Ender | CR10 | KP3S | Ender | CR10 | |
| Skin Overlap Percentage | 5% | 15% | 5% | - | - | ||||
| Infill Overlap Percentage | 10% | 20% | 10% | - | - | ||||
| Printing Temperature | 215°C | 230°C | 255°C | - | - | ||||
| Build Plate Temperature | 60°C | 70°C | 100°C | - | - | ||||
| Print Speed | 100mm/s | 100mm/s | - | - | |||||
| Travel Speed | 180mm/s | 180mm/s | - | - | |||||
| Initial Layer Speed | 30mm/s | 30mm/s | - | - | |||||
| Fan Speed | 50% | 40% | - | - | |||||
| Retraction Distance | 0.8mm | 0.8mm | - | - | |||||
| Retraction Speed | 20mm/s | 20mm/s | - | - | |||||
| Retraction Extra Prime | 0.25mm³ | - | - | ||||||