Raspberry Pi/Wifi Access Point: Difference between revisions

Latest revision as of 18:24, 14 April 2016

install

apt-get install hostapd dnsmasq

/etc/network/interfaces

allow-hotplug wlan0
#iface wlan0 inet manual
#    wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
iface wlan0 inet static
    address 192.168.99.1
    netmask 255.255.255.0

/etc/network/if-pre-up.d/iptables (755)

#!/bin/sh
/sbin/iptables-restore /etc/iptables.ipv4.nat

/etc/default/hostapd

DAEMON_CONF="/etc/hostapd/hostapd.conf"

/etc/hostapd/hostapd.conf

interface=wlan0
driver=nl80211
ssid=SSID
hw_mode=g
channel=6
ieee80211n=1
wmm_enabled=1

macaddr_acl=0
auth_algs=1
ignore_broadcast_ssid=0

wpa=2
wpa_key_mgmt=WPA-PSK
wpa_passphrase=PASSWORD
rsn_pairwise=CCMP

/etc/dnsmasq.d/dnsmasq.conf

interface=wlan0
bind-interfaces
server=8.8.8.8
domain-needed
bogus-priv
dhcp-range=192.168.99.50,192.168.99.100,255.255.255.0,12h

iptables

sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE
sudo iptables -A FORWARD -i eth0 -o wlan0 -m state --state RELATED,ESTABLISHED -j ACCEPT
sudo iptables -A FORWARD -i wlan0 -o eth0 -j ACCEPT
sudo iptables-save > /etc/iptables.ipv4.nat

@@ Line 6: / Line 6: @@
 </blockquote>
+* /etc/network/interfaces
+<blockquote>
+<pre>
+allow-hotplug wlan0
+#iface wlan0 inet manual
+#    wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
+iface wlan0 inet static
+    address 192.168.99.1
+    netmask 255.255.255.0
+</pre>
+</blockquote>
-* /etc/hostapt/hostapd.conf
+* /etc/network/if-pre-up.d/iptables (755)
+<blockquote>
+<pre>
+#!/bin/sh
+/sbin/iptables-restore /etc/iptables.ipv4.nat
+</pre>
+</blockquote>
+* /etc/default/hostapd
+<blockquote>
+<pre>
+DAEMON_CONF="/etc/hostapd/hostapd.conf"
+</pre>
+</blockquote>
+* /etc/hostapd/hostapd.conf
 <blockquote>
 <pre>
@@ Line 40: / Line 66: @@
 </pre>
 </blockquote>
 * iptables